[填空题]

LOW OIL LEVEL COMPR CRANKCASE LSLL-731表示()。

参考答案与解析:

相关试题

A diesel engines crankcase oil level is

[单选题]A diesel engines crankcase oil level is found to be too high√ You should suspect that ().A . the engine was over filledB . there might be a fuel leakC . there might be a water leakD . all of the above

  • 查看答案
  • LOW SURGE TANK AUX.WATER LEVEL表示()。

    [填空题] LOW SURGE TANK AUX.WATER LEVEL表示()。

  • 查看答案
  • Excessive oil foaming in the crankcase o

    [单选题]E.xcessive oil foaming in the crankcase of a refrigeration compressor is most likely to occur when the compressorA.has run continuously for a long periodB.suction pressure is below normalC.oil level is below normalD.starts after a long idle period

  • 查看答案
  • Before pumping up the crankcase oil,() s

    [单选题]Before pumping up the crankcase oil,() should be worked by hand to minimize corrosive action on the liners.A . the indicatorsB . the starting valvesC . the cylinder lubricatorsD . the turning gear

  • 查看答案
  • 当滑油量低于多少时出现“LOW OIL LEVEL”闪烁指示,这时需要给APU加

    [单选题]当滑油量低于多少时出现“LOW OIL LEVEL”闪烁指示,这时需要给APU加滑油()A . 3.9夸脱;B . 4.9夸脱;C . 5.9夸脱。

  • 查看答案
  • The oil-level is indicated with a level gauge and is measured through____ ()

    The oil-level is indicated with a level gauge and is measured through____ ()A. a

  • 查看答案
  • If the temperature drops low enough, oil

    [单选题]If the temperature drops low enough, oil will not flow, () just tell us the temperature.A . Hash pointB . ViscosityC . Pour pointD . Cetane number

  • 查看答案
  • Cylinder lubrication oil for low speed m

    [单选题]Cylinder lubrication oil for low speed main propulsion diesel engines is admitted to each cylinder during ().A . the power strokeB . the compression strokeC . low load operation onlyD . periods of standby

  • 查看答案
  • Can you measure oil level? Which method

    [单选题]C.an you measure oil level? Which method is right, to measure ullage height or to measure oil depth?

  • 查看答案
  • APU工作期间,“APU LOW OIL PRESSURE&rdqu

    [单选题]APU工作期间,“APU LOW OIL PRESSURE”灯亮:().A .要求机组关掉APUB .可以继续使用APU,但不能使用APU引气C .要求机组将APU电门放到”OFF”位后,再放到”START”位1-2秒松手D .APU自动关车

  • 查看答案